For more information, you can also refer to "Single Image for Multiple Specs" and "VLAN and Multiple LANs" in CCBoot v3.0 Wiki.

Features

Design of two-segment or multiple segments, and workstations respectively by two or more network cards on the server connected to the hardware and software installed just as easily, workstations in different network segments, over a different network adapter reads data from the server, this will not only alleviate the pressure on the server network card, but also avoided due to an equipment failure, caused by paralysis of the entire network, or blocked.

Single Network Segment

On CCBoot Server, there are two NICs in the same LAN, CCBoot server settings are as follows:For example, two Server LAN IP is set to: 192.168.1.253; 192.168.1.254
Gateway: 192.168.1.1

• 1, Open the CCBoot Main Interface, click "Options" button, choose "DHCP"Settings tab, on the DHCP server IP selection please choose "0.0.0.0 " IPaddress then click OK.
• 2, Open the User Management, click on client settings interface inside of the boot server IP "fill the need to start the server IP such as 192.168.1.253.
• 3, May fill in first a client, then select default, then the client can start from this network card, then revises this default client again "start server IP", for example: Changes the client which 192.168.1.254 starts that again from 192.168.1.254 this network card to start.

So that you can achieve a single LAN Server dual-NIC machine

Dual Lan Segment

A Server PC installed with two different network cards, CCBoot server settings are as follows:
Such as the two Server LAN IP is: 192.168.1.254; 192.168.0.254
Gateway correspond to: 192.168.1.1; 192.168.0.1

• 1, ON the CCBoot Server open the Main Interface click "Options", DHCP settings, select 0.0.0.0 DHCP server IP saved, others cannot set.
• 2, Open the user management, click client settings interface, start the server in the IP which fill the need to start the server IP. For example, 192.168.0.254, fill the custom gateway: 192.168.0.1.
• 3, May fill in first a client, and then select the default, then the client can start from the NIC, belong to the local area network; start the server and then modify the default client IP and gateway, for example: server IP changed to: custom gateway 192.168.1.254 to: 192.168.; so restart the client from 192.168.1.25

This network connection has started.
This will achieve the dual card Dual LAN with a single server machine.