25.12 UAC Setup

　　1. Click "Windows Start button" select "Run" command, type msconfig and then click "OK" or press "Enter" the system configuration pop up, choose "Tools" as shown in the following figure:

　　2. Select "Change UAC Settings" and click the "Launch" button below, in the pop up dialog box set UAC to minimum (Never Notify).

　　Related links:

　　25.1 Server Hardware

　　25.2 Server Bios SATA Configuration

　　25.3 Server Operating System

　　25.4 Server Hard Disk Allocation

　　25.5 SuperCache method of installation

　　25.6 Server Network Optimization

　　25.6.1 Network Properties

　　25.6.2 NIC Properties

　　25.6.3 NIC aggregation

　　25.7 Server cache settings

　　25.7.1 Server read cache settings

　　25.7.2 Write-back disk SuperCache cache settings

　　25.8 Server’s Virtual Memory Management

　　25.9 The client's local cache settings

　　25.10 Clients Virtual Memory Management

　　25.11 System Restore Point Management

　　25.12 UAC Setup

　　25.13 Client network optimization

　　25.14 System Patches Installation

　　25.15 Clear Windows 7 64bit Water Mark